Merrill Audio Speaker Cables and Interconnects are built to achieve transparency and natural sound, being neutral to the system with unhindered detail and clarity. If the source is good, it will show right through. To achieve this it is necessary that the signal travels as fast as possible, unhindered by inductance, capacitance and resistance.  We use a single metal, the finest OFC copper, to allow the signal to take the optimal path and to ensure and ensures a single arrive time for the entire frequency range.  These translates to natural timbre, optimized detail, control, and transparency.

The configuration of the cables has a very big influence of on the cable sound through the resistance, inductance and capacitance.  To obtain flat frequency response, each of these components must be kept at the lowest level possible.  Low inductance provides proper control and speed, especially at the lower frequency levels; this is combined with cables that also have very low capacitance. The higher gauge wires have lower resistance which helps with speaker control, and minimizes the effects of cable length.  Together, these provide for cables that disappear from the system, allowing the audio systems components to shine.

To keep the low impedance and natural sound, the speaker cables are cold-welded to the highest quality Cardas Rhodium over silver plated spades.  Cold Welding fuses the wire without heat, making it appear as a single continuous wire where the spade is now part of the wire.

Cardas XLR and RCA connectors are used for the Interconnects to keep the integrity of the Interconnect cables and its natural sound.  Using 18 AWG cable for the interconnects in a tight configuration allows for long runs, but also optimizes the sound obtained with short runs.

Achieving the goal of natural sound and transparency, Merrill Audio ANAP series cables let your audio system get to its maximum potential, showing every detail of the music and the audio components. Audio Purity!